ALLIANCE Speed Queen Uživatelský manuál stáhnout pdf (Strana 10)

200944

Washer Operation

Start Up

When power is applied to the washer, the control will

display its software version as “SXXX” (“XXX” is the

version number) for two seconds. If the control was

not powered down during a running cycle, it will enter

the Ready Mode.

Ready Mode

Figure 2

In Ready Mode, the PERM PRESS/WARM (default

cycle) LED is lit, and the full vend price is displayed

as left justified. The user may select a different cycle,

if desired. (In card reader machines, if the current

cycle has a vend price which differs from the default

cycle, the display will be updated to show the new

price.) If another cycle is selected, the control will

flash the amount needed to satisfy the vend shown on

the display. If the vend price is not satisfied within one

minute, the washer control will stop flashing the vend

price and return to the default cycle. The display will

continue to show the remaining vend needed to start a

cycle and will credit any vend entered by the user.

Vends may be satisfied by a coin drop, start pulses, or

by a third party card reader. If a coin drop is used, the

remaining vend price will decrease with each coin

entry. If start pulses are used, the remaining vend price

will decrease with each received pulse. Once the vend

is satisfied, the START LED will begin to flash. If a

third party card reader is used, the START LED will

begin to flash when a valid cash card is entered into

the reader.

When the START keypad is pressed, the washer will

start. The START LED will stop flashing and the

WASH LED will be lit. The display will change to

show the remaining cycle time on the right side of the

display. The appropriate LEDs will light while the

machine passes through different cycle steps. Any coin

entered after the first fill cycle will be added to the

total coin counter, but the user will not be able to

change cycles.

When a cycle is complete, the Four-Digit Display will

show “00” until the lid is opened, a key is pressed, a

coin or card is entered, or a start pulse is received.

When one of these instances occurs, the Four-Digit

Display will revert back to the Ready Mode.

Opening the Washer Lid

Opening the washer lid in a running cycle will

automatically stop the cycle, the Four-Digit Display

will show “LId”, and the timer will stop. Once the lid

is closed, the cycle will resume from the point it was

interrupted. If the washer lid is opened in the last three

minutes of the cycle, the timer will continue to count

down to the end of the cycle. When the timer control

reaches 0 minutes, the control will return to the Ready

Mode.

Signals

There are three instances when a signal may sound

during washer operation. The owner may program the

signal to be turned on or off (refer to Programming

MDC, option 6). These three instances are listed

below:

1. Keypad Depression Signal

The signal will sound for .25 seconds each time a

keypad is pressed.

2. Coin Input/Start Pulse Input/Card Insertion

Signal

The signal will sound for .25 seconds each time a

coin or start pulse is received or a card is entered.

3. Machine Error Signal

The signal will sound for 15 seconds if an error

occurs.

TLW2R

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

Komentáře k této Příručce

Žádné komentáře

ALLIANCE Speed Queen Uživatelský manuál Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Pračky ALLIANCE Speed Queen